SWAROVSKI thermoadhesive rhinestones 1440pcs Smoked topaz SATIN hotfix

SWAROVSKI thermoadhesive rhinestones 1440pcs

Smoked topaz satin hotfix

• S6(1.90-2.10mm) 1440pcs (10 gross)

• SS16(3.80-4.00mm) 1440pcs (10 gross)

• SS20(4.60-4.80mm) 1440pcs (10 gross)

INSTRUCTIONS FOR ATTACHING THERMO-ADHESIVE MATERIALS

Any thermoadhesive material can be applied in 4 different ways a

depending on the surface on which you want to stick it, the

size of the material and the number of pieces you want to attach.

The four modes are:

1) RHINESTONES APPLICATOR

2) A FLAME

3) GLUE

4) IRON

1) THE APPLICATOR FOR RHINESTONES and STUDS: allows for a lot of work

precise by being able to attach rhinestones or studs in "difficult" or even positions

objects that cannot be spread out on a flat surface, shoes, jeans pockets,

wedding favors…. The tip is chosen depending on the size of the material

that you want to apply, wait 3 minutes for the applicator to heat up

then all you have to do is position the rhinestone or stud, it rests

the tip of the applicator over the material for 20 seconds going like this

to heat the glue found under the rhinestone, remove the tip and wait

allow the material to cool for a few seconds, at which point it is attached.

2) A FLAME which could be from a candle, from a camping stove….

Can be used for any stud or rhinestone.

It works like this: you take the material (rhinestone or

studs) and heat the glue behind the rhinestone, positioning the material

on the flame for a few seconds, then as soon as it melts, apply the material

on the surface on which you want to attack, at that point you wait for it

cool a few seconds and the rhinestone or stud is attached.

3) THE GLUE: it is necessary to use "soft" glues such as Gutermann ht2 glue

o Attak flex gel (“glassy” glues like normal Attak do not last long).

Glue can be used for any material but is mandatory in

moment in which studs or rhinestones are to be applied to plastic, wood,

ceramic, glass…. Non-porous surface where the glue of the rhinestone or the

stud cannot penetrate and cannot "grip".

4) THE IRON: it is used to speed up times when necessary

attach lots of rhinestones or lots of studs nearby; in this case yes

they place the rhinestones on the surface where you want to apply them, you put them on

over the iron for 20 seconds. The operation is repeated if it is not possible

heat all the rhinestones at once; at this point we leave

cool everything for a few minutes and the materials are attached.

In this case, however, there is the risk that once the iron is placed

ironing over the surface could move the materials or it could

ruin the fabric because part of the iron comes into contact

with the surface on which you want to apply the thermoadhesive materials;

to overcome this problem we recommend using RHINESTONE PAPER

which is used to hold the rhinestones in place and protect the surfaces on which they are placed

go to apply the materials.

the photos contained in this site are of our production and therefore of

our exclusive property and are therefore protected by the regulations on

copyright law 633/41; presidential decree 19/79; Legislative Decree 154/97